VIRTUOSO PRO

The VIRTUOSO PRO features a balanced audio design and uses a dual 3.5mm cable on the headset side which requires both connections to function. An “L” and “R” are indicated on the inside of the headband and the corresponding 3.5mm jack. The microphone boom (G) connects to the left 3.5mm port (A).

You can connect the VIRTUOSO PRO using the 3.5mm jack to any PC, Mac, PlayStation 4/5, XBOX Series*, Nintendo Switch, or mobile device using the 3.5mm headphone jack.

For devices that have individual headphone and microphone inputs, you can use the included Y-Adapter cable (I).

Place the headset on your head and adjust the headband for a comfortable fit.

The plush memory foam ear pads enable the VIRTUOSO PRO headset to fit comfortably, so you can play and listen for hours
without fatigue.

*May require Microsoft adapter (sold separately).

NOTE: Prolonged listening at high volumes may adversely affect your hearing. Take breaks between sessions and always begin with the volume at a low level before increasing.

Slide down on the microphone mute toggle to mute. Slide up on the microphone mute toggle to unmute (F). For best performance, bend the flexible microphone boom to best fit near the left corner of your mouth. We’ve found that a 30-degree bend is a good place to start, but feel free to increase or decrease this if your mic is too loud or too soft.

The ear pads for the VIRTUOSO PRO are user-replaceable. Twist the ear pads to detach. Twist the ear pads in reverse to attach.

The speaker tags for the VIRTUOSO PRO are user-replaceable. To remove the speaker tag, locate the notch at the bottom of the headphone cup. Gently pull the speaker tag away from the headphone cup housing.

To attach the speaker tags, align the arrows on the speaker tag with the arrow on the inside of the headphone cup housing and press gently
to install.

The headband cushion is user-replaceable. The cushion is attached with clips at the ends and in the center. Compress the headband slightly and pull the headband cushion downwards with both hands.

To attach the headband cushion, slightly compress the headband first. Align both pairs of clips on the left and right of the headband with the slots in the cushion. Push the headband cushion up and snap the middle of the headband together.

The top outer CORSAIR Logo band slides off from right-to-left.