How to set up CORSAIR RX RGB fans in iCUE

Add to your iCUE LINK ecosystem with another CORSAIR RX120 RGB 120mm PWM Fan, delivering superior airflow at speeds up to 2,100 RPM while producing our lowest tested noise levels. Thanks to patent-pending iCUE LINK technology, your fans can connect seamlessly together, all connected to an iCUE LINK System Hub (sold separately) with a single cable. Eight RGB LEDs shine with your custom lighting effects, with a built-in side window for more viewing angles. CORSAIR AirGuide Technology focuses airflow where it’s needed most while a Magnetic Dome bearing ensures high longevity and low noise, alongside Zero RPM mode for virtual silence at low loads.

1. Make sure you are using the latest version of iCUE, at least iCUE version 5.12.97.
2. During the initial setup, a module for your iCUE LINK System Hub and the iCUE LINK RX RGB fans will be installed in iCUE.
3. You may be prompted to update the firmware of the iCUE LINK System Hub.
4. This can also be done manually:
5. Click on your iCUE LINK System Hub.
6. Select "Device Settings".
7. Click "Check for Updates".
   
   

1. Then select "Lighting Setup".
2. Click the "Run Wizard" button.
3. Click "Next" to start the fan setup.
4. The RX RGB fans will now light up in the colors shown in the setup wizard.
5. If the order of the RX RGB fans in your setup is different from that shown in iCUE, you can use Drag & Drop to arrange them correctly.
6. Click "Finish" to complete the setup.
   
   

1. Select the RX fans from the Home menu.
2. Under "Lighting Playback", you can select both "Lighting Effects" and "Hardware Lighting".
3. Click on "Lighting Effects".
4. Under "Lighting Layers", click on the "+" symbol.
5. You can now choose from many different RGB effects.
6. The Time Warp effect is only available with the QX RGB fans.
7. As an example, we choose the RGB effect "Sequential".
8. This RGB effect should run on "All" RX fans.
9. We set the speed to "Slow."

1. Select "Cooling" to set your RX RGB fans with different fan curves.
2. We provide 3x presets:
   1. "Quiet" - sets the fans down untill 0 RPM.
   2. "Balanced" - adapts to the system load.
   3. "Extreme" - lets the fans rotate continuously at high RPM.
3. You can create your own fan curves by clicking on the "+" symbol:
   1. "Fixed %" - sets a fixed percentage value.
   2. "Fixed RPM" - sets a fixed RPM value.
   3. "Temp Curve" - create your own fan curve using 7x values. Sensor is individually selectable.
   4. "Load Curve" - create a fan curve based on 5x values. Sensor is individually selectable.