Mount a Pro XT or Platinum cooler
Most new Corsair liquid coolers are compatible with AMD’s AM4 socket out-of-the-box. You do not need to use the AM4 AMD Retention Bracket Kit if you have one of the following coolers:
- iCUE H100i Elite Capellix
- iCUE H115i Elite Capellix
- iCUE H150i Elite Capellix
- iCUE H100i Pro XT
- iCUE H115i Pro XT
- iCUE H150i Pro XT
- H100i Platinum
- H115i Platinum
- H100i Platinum SE
- H100x
- H60 (2018 model)
To install your cooler in an AM4 system, you will need the following hardware:
- 1 AM4 mounting bracket (L)
- 2 AMD screw clips (D)
- 2 thumbscrews (E)
![mceclip0.png](https://help.corsair.com/hc/article_attachments/360051160272/mceclip0.png)
To mount your cooler using the AM4 socket:
- Remove the pre-installed Intel mounting bracket from the cooler.
- Install the AMD bracket by pushing both sides into the slot on the pump.
- Make sure the bracket is evenly secured on all sides before installing your cooler.
- Install the AMD screw clips into the bracket and secure them with the thumbscrews.
- Do NOT tighten the thumbscrews all the way. You need to have enough slack to get the screw clip loops over the retention hooks of the mounting clip.
- Align your bracket with the stock AMD mounting clips and install the cooler by slipping the screw clip loops over the retention hooks.
- Tighten the thumbscrews until the cooler is secure.
- Do NOT overtighten the thumbscrews. Doing so will damage the retention hooks.
If you want to see diagrams or more detailed installation instructions, consult your cooler product manual. If you cannot find your product manual, you can use this manual for the H100i Platinum.
You can also check out our video on installing coolers:
Mount a Hydro or Pro cooler
Older models are not compatible out-of-the-box, but you can use the following coolers with the AM4 socket if you also have the AM4 AMD Retention Bracket Kit:
- H50
- H55
- H75
- H80i v2 (H80i GT)
- H90
- H100i v2 (H100i GTX)
- H105
- H110i GTX
- H115i
Here is what’s included in the AM4 AMD Retention Bracket Kit:
- (1) AM4 bracket for circular pumps
![blog_AM4BracketInstallation-Content-2_1_.jpg](https://help.corsair.com/hc/article_attachments/360024480531/blog_AM4BracketInstallation-Content-2_1_.jpg)
- (4x) Collared standoffs
![blog_AM4BracketInstallation-Content-3_1_.jpg](https://help.corsair.com/hc/article_attachments/360024463852/blog_AM4BracketInstallation-Content-3_1_.jpg)
- (4x) Thumbscrews
AMD AM4 Mounting Kit installation instructions:
- Remove the stock AMD mounting clips from the front of your motherboard.
- Insert the AM4 standoffs into the original AMD back plate, collared side down.
- Replace the stock Intel bracket on your Hydro Series cooler with the AMD bracket provided in the kit.
- From there, proceed with your typical Hydro Series cooler installation (don't forget to plug in your power and USB cables).
For more information, consult your user's guide or check out our forums!