CORSAIR DESK CLAMP ADAPTER FOR XENEON FLEX

In accordance with our policy of constant improvement, we reserve the right to alter specifications of products shown.

1. Find a flat surface where you can lay the FLEX monitor down flat and place a piece of soft material on the surface to protect the panel.
2. Remove the monitor stand base by turning the thumb screw counter-clockwise.

1. First, take the FLEX Desk Clamp out of the box.
2. Next, adjust both knobs to the bottom position.
3. Finally, the Desk Clamp is designed to fit onto a desk with a maximum thickness of 5cm.

1. Insert the FLEX Desk Clamp onto the bottom of the FLEX monitor stand where you removed the base.
2. Using the included Allen Key, turn the M4 screw clockwise until it is secured firmly in place.

1. Clear off your desk or table area where you want the FLEX monitor to be attached.
2. Carefully pick up the FLEX monitor by the rear stand being careful not to touch the panel and move it into place on your desk.
3. Make sure that you or your helper holds the monitor in place while tightening the clamp knobs.
4. Hand-tighten the knobs until they are secured firmly in place.
5. Connect your cables to the FLEX monitor per user manual.
6. LINK TO FLEX QSG on CORSAIR.COM

1. The Desk Clamp is specifically designed for CORSAIR XENEON FLEX and should not be installed with any other device. Please note that the weight limit is 9.3kg, and exceeding this limit could lead to the Desk Clamp failing, potentially causing damage to your equipment or posing a risk of injury to individuals nearby.

2. Always ensure that the Desk Clamp is securely fastened to the desk or table before attaching any equipment. Failure to do so may cause the Desk Clamp to loosen and your equipment to fall or become damaged.

3. Do not place the Desk Clamp in a location that interferes with the operation of other equipment or poses a hazard to individuals in the vicinity.

4. Only use the Desk Clamp for its intended purpose. Do not modify or alter the Desk Clamp in any way, as this may compromise its stability and lead to accidents or injuries.

5. When installing the Desk Clamp, ensure that all hardware is tightened properly and securely. Loose hardware may cause the Desk Clamp to fail or become unstable.

6. Always use caution when adjusting the position or angle of the attached equipment. Sudden movements or excessive force may cause the Desk Clamp to fail or your equipment to become damaged.

7. Do not allow children or untrained individuals to install or operate the Desk Clamp. Only individuals who are familiar with the installation process and safety precautions should attempt to install or use the Desk Clamp.

1. By installing and using the Desk Clamp, you agree to assume all risks and liabilities associated with its use.
2. We are not responsible for any damage or injury resulting from the use or installation of the Desk Clamp. It is the responsibility of the user to ensure that the Desk Clamp is installed and used correctly and safely.
3. We are not liable for any incidental or consequential damages resulting from the use or installation of the Desk Clamp, including but not limited to, loss of data or equipment, personal injury, or property damage.